■ “Air-purging” Without Problems or Loss Reagents.
    Turn the operation mode selector to the right at a 90˚ angle. A maker and the
    discharge tube  will indicate the right position. Remove (purge) the air by 
    several pumping actions. 
    No reagent is lost as you are pumping in a closed circuit.

■ NO More Spills : NO Reagent Loss.
   Residual reagent to be dispensed is not lost when working with the TITREX 2000. 
   For environmental and cost reasons reagents can be transfered easily without loss.
   Turn the operation mode selector 90˚ to the right and the residual amount 
   inside the cylinder will be pumped back into the bottle or container.

■ Safe & Secure Restposition.
    By turning the operation mode selector by 180˚ all liquid in the discharge tube 
    flows back  into the bottle. It is almost impossible for any leakage to occur 
    when it is in that position. 
    The TITREX 2000 is completely shut down and no accidental discharge will occur 
    by inadvertently moving the position. 
    This is clearly indicated by the position of the tube and the setting of the 
    operation mode.

■ Auto-Calibration.
    The permanent calibration of the TITREX 2000 is adjusted to water at 20˚.
    For liquids of different viscositiesd / densities the TITREX 2000 can be easily 
    recalibrated  by pushing the button “O/CAL”- just follow the detailed 
    instructions of the manual.

■ Parctical & Fast Pre-selection of Volumes Needed for Titrations.
    Just push the key “DOS” and you can pre-select the burette-volume for your
     titrations.
    By watching the display you always can control the volume of liquid, that 
    you suck-in  to the burette cylinder. Press the button “zero” and titration
    can start immediately. 
    It could not be quicker, handier and more accurate than with a glass burette 
    and more sensitive than with a motor dirven burette. 
    The key “MEM” (memory) helps to avoid complicated calculations.

■ Up to 500 Data Sets maybe stored in the memory and are available for data 
   evaluation on PC   or Printer.
   Together with the “WITOLINK” software specific evaluations are possible 
   : Option.

■ “Auto-Off” power after 3 minutes, and a Flashing Alarm for the Battery Changing.

* TITREX 2000™은 일반 유리 Burette 보다 변환점이 빠르고 민감함. 또한 Motor Burette
  보다 가격이  저렴함.
* Witeg TITREX 2000™ 만이 Titrating 과정중에 몸체가 상하로 이동하지 않는 유일한 
  Digital Burette임.
* 분주 속도는 손잡이 (Hand Wheel)를 돌리는 속도에 따라 무단 가감속됨. 왼손/오른손
  겸용.
* 최종 사용후 3분 경과시 자동 Cut-off.
* 사용하고 남은 뷰렛내의 시약을 병속으로 완전회수.
* 기본형과 정밀형 2-모델, 정밀형은 미량 (0.**ml)조절용 Fine Controller 장착.
* 기구내에서 기포 완전제거 “Air-purging”
* 자동 보정/메모리 기능.

* ‘CAL’ Button에 의한 쉬운 보정 “Auto-Calibration
* 약품손실 zero(0) 
* 작동온도 10 - 40℃, 보관온도 최대 60℃
* Battery 충전식 AC/DC 겸용.                                             
* Range : 0 ~ 50 (0.01) ml, ±0.1% 이내
* Complete Set로 공급됨 : 2 Lit. 갈색병, 재충전식 Battery, AC 220 V Adapter 및 
  Screw connect, Adapters